Path Analysis

Used to track time and distance covered for a specific task. All the analytics are given to decide routing methods for specific models.

To create a path, enter panels and go to the ‘Path Analysis’ tab. ‘Record New’ allows the recording a new path while ‘Review Paths’ gives the analysis for any saved paths.

From the ‘Record New’ panel the sample rate can be changed, this polls how much time should pass between points on the path being recorded. The three buttons below describe the three different ways to start recording.

Once a recording has started it will measure the head movement of the user’s avatar and what models are moved. Once finished the recording can be ended and it will give the analysis of the path.

A replay of the path can be started via the play button in the panel. Playing the path will show both the model ghost and the avatar moving.

Saving sets the path to be saved upon the layout being saved.

CMA Mode

‘Component Manipulation Analysis’ utilises ‘Path Analysis’ but a specified position can be given that the model selected must move to. The mode can be activated from within the Path Analysis panel.

Selecting ‘Motion Analysis’ opens a new panel where a component can be selected. Before the component is selected, the component should be placed in the location where the model should end.

Once a component is selected it can be moved to the starting location and ghost will remain at the end location. When in the starting location select ‘Confirm Position’. A path can then be made by moving the component back to the ghost.