Dynamic Clashing Walls

To enable the wall drawing tool select Dynamic walls from the experience menu. Once selected the default height for the wall can be adjusted using the slider.

To draw a wall:

RE: Click and drag the pointer when pointed at the floor from one spot to another. Release the click when finished with the wall length.

VR: Press and hold the right trigger while pointed at the floor. Drag the wall out using the pointer and selection button and release the trigger when finished.

Multiple walls can be drawn together by selecting near the edge of one wall and attempting to draw another one.

The size of the wall can be changed by selecting the measurement tool tip on the wall.

Another panel will be overlaid allowing the measurement to be edited.

To change the visibility of the wall select the button labelled ‘Cycle Wall Visibility’. This will transition between the different states the wall can be in. Currently there is solid, half and line.

Once a part intersects the wall it will highlight red shown by the images below: